Artesyn ViewCheck on ATCA-9405 Installation and Use (Septe User Manual download pdf (Page 28)

Installation of ViewCheck

ViewCheck on ATCA-9405 Installation and Use (6806800S51E)

Username: Admin

Password:

Access granted

>enable

#configure terminal

BSF(config)#

4. Select Virtual Execution Environment as below:

 On SP, use the virExecEnv SP_VEE0 options in the virExecEnv

BSF(config)#virExecEnv virExecEnv SP_VEE0

BSF(VEE-SP_VEE0)#diagnostic

BSF(diag-SP_VEE0)#

 On PP, use the OCTEON1_VEE0/OCTEON1_VEE1 options in the virExecEnv

BSF(config)#virExecEnv OCTEON1_VEE0

BSF(VEE-OCTEON1_VEE0)#diagnostic

BSF(diag-OCTEON1_VEE0)#

After logging into the ViewCheck CLI, you can list all the supported commands by typing '?'

on the CLI console.

BSF(diag-SP_VEE0)#?

configure-error-strings User configurable error strings, notified

by ViewCheck when reported by the device.

configure-log-path Configures the log path where the resluts

are stored.

device-category Configure deviceCategory

diag-service Diag operation(start/stop/restart).

exit Exit from diagnostic

hw-inventory-list Provides the Inventory of Hardware (Type,

Vendor ID, Major Number, Minor Number and

any associated Details) as detected by the

Diagnostics Application.

By default, the administrator user name and password are "Admin".

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 89 90

No comments

Artesyn ViewCheck on ATCA-9405 Installation and Use (Septe User Manual Page 28