Artesyn ViewCheck on ATCA-9405 Installation and Use (Septe User Manual download pdf (Page 84)

Commands Execution

ViewCheck on ATCA-9405 Installation and Use (6806800S51E)

 NwMemAcessTest (SP): Accesses various memory areas (listed below), accessible by the

device and performs Pattern read/write operations (incremental values, random values

and 0xAA, 0x55) on the memory area. This test ensures the device is able to access those

memories for read and write operations. Frequent failures of this test can be treated as

malfunctioning hardware.

Applicable memory types:

– Buffer DRAM

– MAC table memory

– VLAN table memory

 NwCntlrRegAcessTest (SP): Tests the ability to read and write into device registers that

are accessible by writing various patterns ( 0xAA_0x55, Random value, Bit Toggle,

incremental) in to them. This test ensures the accessibility of registers by Switch. Frequent

failures of this test can be treated as malfunctioning hardware.

 TcamSelfTest (SP): Invokes the built-in self test of the Ternary Content Addressable

Memory (TCAM) on both policy control lists and router sections. This test does not restore

data relevant TCAM area. This test ensures TCAM accessible to the switch. Frequent

failures of this test can be treated malfunctioning hardware.

 NetworkThroughputServ: Starts the server for network throughput testing.

 NetworkThroughput: Tests the network throughput.

 NetworkTxBenchMark (SP): Checks the transmission rate of interface

4.6.8 FPGA

 CPLDTest (SP): This test checks the accessibility of the CPLD device by performing write

and read operations on scratch registers of CPLD device.

 FPGATest (SP): This test checks the accessibility of the FPGA device, by performing write

and read operation on scratch registers of FPGA device.

The TcamSelfTest is destructive test and cannot be run during presence of network traffic.

Board reboot is required after every run of this test.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 90

No comments

Artesyn ViewCheck on ATCA-9405 Installation and Use (Septe User Manual Page 84