Artesyn System Management Interface Based on HPI-B (Centel User Manual download pdf (Page 35)

Software Installation and Configuration

System Management Interface Based on HPI-B (Centellis 2000 R3.0/4411) User’s Guide (6806800P20C)

2.4.2 Configuring an SNMP Agent

Once the SNMP agent files are installed and the single shelf library used by the SNMP subagent

is configured appropriately as described in the previous sections, you need to configure the

SNMP master agent as follows.

Configuring the SNMP Master Agent

The following configurations can be grouped into the following categories:

 General configuration

 SNMP V2 and V3 related configuration

 Trap message configuration

1. Open the SNMP master agent configuration file /etc/snmp/snmpd.conf in a

text editor

2. Make sure that the file contains the following entries:

master agentx

AgentXTimeout 600

AgentXRetries 20

The values specified for AgentXTimeout and AgentXRetries should have at

least the values 600 and 20.

3. In order to configure the SNMP master agent for SNMP V2, add the following line to

snmpd.conf:

com2sec notConfigure default rwcommunity

rwcommunity public

To test the SNMP V2 configuration, save the configuration file and perform a SNMP

walk by entering the following command at the ATCA-MF106/SAM1411 command

line:

/etc/init.d Contains HPI-B SNMP daemon start/stop scripts

Table 2-10 Overview of SNMP Agent Related Directories and Files on ATCA-MF106/SAM1411

Directory Description

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 135 136

No comments

Artesyn System Management Interface Based on HPI-B (Centel User Manual Page 35