MOTLoad Commands
MOTLoad Firmware Package User’s Manual (6806800C24D)
184
3.1.96 testRamBounce
Name
testRamBounce—writes all ones to all memory addresses within the default or specified
memory block, then performs a read-back and verify of each memory address. If a mis-
compare is detected, an error is logged. This operation is repeated a second time but the write
data is all zero.
Note: testRamBounce only test memory in blocks, thus specifying a memory area size that is
not a multiple of the block size results in part of the memory area being untested.
Synopsis
testRamBounce [-a] [-b] [-i] [-n] [-t] [-v]
Parameters
-a Ph: Address to Start (Default = Dynamic Allocation)
-b Ph: Block Size (Default = 16 KB)
-i Pd: Iterations (Default = 1)
-n Ph: Number of Bytes (Default = 1 MB)
-t Pd: Time Delay Between Blocks in OS Ticks (Default = 1)
-v 0: Verbose Output
Example
The following example indicates a typical display when using the testRamBounce command.
MOTLoad> testRamBounce -v
Executing RAM Bounce: PASSED
See Also
testRam, testRamAddr, testRamAlt, testRamBitToggle, testRamCodeCopy, testRamMarch,
testRamPatterns, testRamPerm, testRamQuick, testRamRandom
Comments to this Manuals