Artesyn MVME6100 Single Board Computer Installation and Us User Manual download pdf (Page 45)

MOTLoad Firmware

MVME6100 Single Board Computer Installation and Use (6806800D58H)

Usage: testRam [-aPh] [-bPh] [-iPd] [-nPh] [-tPd] [-v]

Description: RAM Test [Directory]

Argument/Option Description

-a Ph: Address to Start (Default = Dynamic Allocation)

-b Ph: Block Size (Default = 16KB)

-i Pd: Iterations (Default = 1)

-n Ph: Number of Bytes (Default = 1MB)

-t Ph: Time Delay Between Blocks in OS Ticks (Default = 1)

-v O : Verbose Output

MVME6100>

3.5 Firmware Settings

The following sections provide additional information pertaining to the VME firmware settings

of the MVME6100. A few VME settings are controlled by hardware jumpers while the majority

of the VME settings are managed by the firmware command utility vmeCfg.

3.5.1 Default VME Settings

As shipped from the factory, the MVME6100 has the following VME configuration

programmed via Global Environment Variables (GEVs) for the Tsi148 VME controller. The

firmware allows certain VME settings to be changed in order for the user to customize the

environment. The following is a description of the default VME settings that are changeable by

the user. For more information, refer to the MOTLoad User’s Manual and Tundra’s Tsi148 User

Manual, listed in Appendix C, Related Documentation.

 MVME6100> vmeCfg -s -m

Displaying the selected Default VME Setting

- interpreted as follows:

VME PCI Master Enable [Y/N] = Y

MVME6100>

The PCI Master is enabled.

 MVME6100> vmeCfg –s –r234

Displaying the selected Default VME Setting

- interpreted as follows:

VMEbus Master Control Register = 00000003

MVME6100>

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 119 120

No comments

Artesyn MVME6100 Single Board Computer Installation and Us User Manual Page 45