Artesyn Centellis 2000 User Card-10GE Installation and Use User Manual download pdf (Page 40)

Board Exchange

Centellis 2000 User Card-10GE Installation and Use (6806800H33C)

Installation Procedure

The following procedure describes the installation of the board. It assumes that your system is

powered. If your system is not powered, you can disregard the blue LED and thus skip the

respective step. In this case it is a purely mechanical installation.

1. Put on an ESD wrist strap.

2. Connect the strap to the shelf by attaching the front or rear ESD jack /ESD snap.

3. Insert the board into the shelf by placing the left and right edges of the board in the

card guides of the shelf. Ensure that the guiding module of shelf and board are

aligned properly. The alignment pin facilitates the insertion and prevents bent pins.

4. Slide the board into the shelf by using the extraction handles until you feel

resistance.

5. Wait until the blue LED is illuminated.

6. Tighten the screws on the left and on the right of the board.

In this way the handle switch activator is closed and the board can be powered. The

blue LED blinks.

7. Wait until the blue LED is switched off.

The switched off blue LED indicates that the board is activated.

8. Attach cables to the front panel connectors as necessary.

4.4 Removing the Board

This section describes how to remove the board from an AdvancedTCA system.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 53 54

No comments

Artesyn Centellis 2000 User Card-10GE Installation and Use User Manual Page 40