Artesyn Centellis 2000 User Card-10GE Installation and Use User Manual download pdf (Page 31)

Chapter 3

Centellis 2000 User Card-10GE Installation and Use (6806800H33C)

Controls, Indicators and Connectors

3.1 Face Plate

The following figure highlights the position of LEDs and connectors on the face plate of the

board. The LEDs and connectors are described in sections LEDs on page 31 and Ethernet

Connectors on page 32.

3.1.1 LEDs

The following LEDs can be found on the face plate of the board. OOS, OK and H/S are ATCA LEDs

and can be controlled via IPMI. For more information, see the Centellis 2000 User Card-10GE:

Control via IPMI Programmer’s Reference manual.

Figure 3-1 Face Plate

Table 3-1 Face Plate LEDs

LED Color Description

OOS (failure) Red Red: The Centellis 2000 User Card-10GE is out-of-service.

Off: The Centellis 2000 User Card-10GE is working properly.

OK (power) Green Green: The Centellis 2000 User Card-10GE is operating

properly.

Off: Otherwise

Blinking: The board boots up.

H/S Blue Blue: The Centellis 2000 User Card-10GE is ready to be

extracted.

Off: The Centellis 2000 User Card-10GE is not ready to be

extracted. Do not remove the board during this state.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 53 54

No comments

Artesyn Centellis 2000 User Card-10GE Installation and Use User Manual Page 31