Artesyn Centellis 2000 User Card-10GE Installation and Use User Manual download pdf (Page 46)

Centellis 2000 User Card-10GE Installation and Use (6806800H33C)

Safety Notes

Operation of this equipment in a residential area is likely to cause harmful interference in which

case the user will be required to correct the interference at his own expense. Changes or

modifications not expressly approved by Artesyn could void the user's authority to operate the

equipment. Board products are tested in a representative system to show compliance with the

above mentioned requirements. A proper installation in a compliant system will maintain the

required performance. Use only shielded cables when connecting peripherals to assure that

appropriate radio frequency emissions compliance is maintained.

Installation

Before installing the board, make sure the requirements listed in section "Board Exchange" are

met.

Restricted access area - This board is only to be installed in a restricted access area.

Data Loss

Removing the board with the blue LED still blinking causes data loss.

Wait until the blue LED is permanently illuminated, before removing the board.

Damage of Circuits

Electrostatic discharge and incorrect board installation and removal can damage circuits or

shorten their life.

Before touching the board or electronic components, make sure that you are working in an

ESD-safe environment or wear ESD wrist straps.

Board Malfunctioning

Incorrect board installation and removal can result in board malfunctioning.

Make sure that the board is connected to the system backplane via all assembled connectors

and that power is available on all zone 1 power pins.

Damage of the Product

Incorrect installation of the product can cause damage of the product,

Only use handles when installing/removing the product to avoid damage/deformation to the

face plate and/or PCB.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53 54

No comments

Artesyn Centellis 2000 User Card-10GE Installation and Use User Manual Page 46