Artesyn ATCA-F120 Installation and Use (August 2014) User Manual download pdf (Page 36)

Hardware Preparation and Installation

ATCA-F120 Installation and Use (6806800D06J)

Removal Procedure

The following procedure describes how to remove the blade from a system. It assumes that the

system is powered. If the system is unpowered, you can disregards the blue LED and thus skip

the respective step. In that case it is a purely mechanical procedure.

1. Unlatch the lower handle by squeezing the lever and the latch together and turning

the handle outward only enough to unlatch the handle from the face plate. Do not

rotate the handle fully outward.

The blue LED blinks indicating that the blade power-down process is ongoing.

2. Wait until the blue LED is illuminated permanently, then unlatch the upper handle

and rotate both handles fully outward.

3. Remove face plate cables, if applicable.

4. Unfasten the screws of face plate until the blade is detached from shelf.

5. Remove the blade from the shelf.

2.7 AMC Modules

The blade provides two AMC bays: AMC B4 and AMC B1. Their location is shown in the

following figure.

Data Loss

Removing the blade with the blue LED still blinking causes data loss.

Wait until the blue LED is permanently illuminated, before removing the blade.

If the LED continues to blink, a possible reason may be that upper layer software rejects the

blade extraction request.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 121 122

No comments

Artesyn ATCA-F120 Installation and Use (August 2014) User Manual Page 36